Note t
| Always use the assembly sleeves to fit the O-rings. There is a danger of damaging the O-rings if the sleeves are not used. |
t
| Gradual introduction of O-rings with no coloured markings. Note the correct allocation of O-rings to grooves: the thickness of the rings reduces towards injector nozzle: |
t
| Prevent O-rings from rolling when sliding them on. The O-rings must not be twisted in their seats in unit injector. |
–
| Pull heat shield seat off together with securing clip. |
–
| Clean O-ring seating surfaces on unit injector very carefully. |
|
|
|