–
| Lubricate threaded head of oil seal extractor -VAS 3240-, place it in position and while exerting firm pressure, screw it into oil seal as far as possible. |
–
| Loosen knurled screw and turn inner part against camshaft until the oil seal is pulled out. |
Note The oil seal sealing lip must not be additionally oiled or greased. |
–
| Remove oil residue from camshaft journal using a clean cloth. |
–
| Mask off groove on taper of camshaft using commercial adhesive tape (e.g. Sellotape). |
–
| Fit oil seal carefully on camshaft. |
|
|
|