Volkswagen Workshop Service and Repair Manuals > Golf Mk5 > Power unit | 4-cylinder diesel engine (2.0 l engine, 4 valve) | Enginecrankshaft group, pistons | Crankshaft | Pulling needle bearing out of and driving into crankshaft

Pulling needle bearing out of and driving into crankshaft

Vehicles with direct shift gearbox only

Special tools and workshop equipment required

t	Puller -T10055-

t	With adapter -T10055/3-

t	Centring mandrel -3176-

t	or drift -VW 207 C-

t	Puller, e.g. Kukko -21/2-

Note

Vehicles with dual clutch gearbox, the needle bearing must be installed in rear end of crankshaft.

Removing

–	Pull out using commercially available puller, e.g. Kukko 21/2 -arrow-, adapter -T10055/3- and puller -T10055-.

Installing

Note

The lettering on the needle bearing must be visible when installed.

–	Drive in with drift -VW 207 C- or centring mandrel -3176-.

Installation depth: dimension -a- = 2 mm.

Volkswagen Workshop Service and Repair Manuals