Volkswagen Workshop Service and Repair Manuals > Golf Mk5 > Power unit | 4-cylinder injection engine (1.4 l direct injection engine, turbocharger) | Exhaust system | Removing and installing parts of exhaust system | Installation position and specified torque of clamp

Installation position and specified torque of clamp

Note

Gradual introduction of clamp with continuous clip.

Specified torque and mounting dimensions of clamping sleeve.

Clamp -A- with 2 individual clips.

Specified torque 25 Nm.

Length: 95 mm

Installation dimensions -a- 5 mm (only for front clamp)

Clamp -B- with continuous clip.

Specified torque: 35 Nm.

Length: 88 mm

Installation dimensions -a- 8.5 mm (only for front clamp)

Installation dimension -a- for vehicles with marking -A- on front exhaust pipe

1 -

Clamp

2 -	Front exhaust pipe

3 -	Securing nut

4 -	Securing nut

a -	Installation dimension

A -

Marking

Installation position of front clamp

–	Install clamp so that end of bolt -arrow- does not extend beyond lower edge of clamp.

l	Threaded connection faces right.

Installation position of rear clamp

–	Install clamp so that end of bolt -arrow- does not extend beyond lower edge of clamp.

l	Threaded connection faces to rear.

Volkswagen Workshop Service and Repair Manuals