volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Fuel supply, gas operation > < Removing and installing coolant pump pulley

Golf Mk5

Removing and installing coolant circulation pumpV50
   
Removing and installing coolant circulation pump -V50-
Special tools and workshop equipment required
t  Refractometer -T10007-
t  Hose clip pliers -VAS 6340-
t  Torque wrench (5…50 Nm) -V.A.G 1331-

Removing
Engine codes BLG, BMY
   
–  Remove securing bolts -arrows- of engine splash protection.
Engine code BWK
–  Depending on vehicle equipment, remove noise insulation or skid plate → General body repairs, exterior; Rep. gr.50.
–  Drain coolant → Chapter.
  N10-10175
–  Remove spring-type clips -arrows- and pull coolant hoses off.
–  Pull connector -1- off and remove securing bolt -2-.
–  Remove coolant circulation pump -V50-.
Installing
Installation is carried out in the reverse order. When installing, note the following:
Specified torque for securing bolt: 10 Nm.
  N19-10172

Fuel supply, gas operation > < Removing and installing coolant pump pulley