volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing sealing flanges and flywheel or drive plate > < Installing

Golf Mk5

Removing and installing ancillary bracket
Removing and installing ancillary bracket
Special tools and workshop equipment required
   
t  Torque wrench (5…50 Nm) -V.A.G 1331-
Removing
Golf, Golf Plus, Touran
  W00-0427
–  Remove securing bolts -arrows- of engine splash protection.
Tiguan
–  Depending on vehicle equipment, remove noise insulation or skid plate → General body repairs, exterior; Rep. gr.50.
Continuation for all vehicles
–  Remove poly V-belt.
Removing and installing (engine codes BLG, BMY) → Chapter.
Removing and installing (engine code BWK) → Chapter.
–  Remove alternator → Electrical system; Rep. gr.27.
–  Remove air conditioner compressor → Heating, air conditioning system; Rep. gr.87
  Note
The air conditioning system lines must not be opened.
–  Secure air conditioner compressor to lock carrier.
–  Ensure that lines are not kinked.
  N10-10175
–  Unscrew securing bolts -1- and remove bracket.
Installing
–  Fit ancillary bracket to cylinder block.
  N13-10306
–  Tighten securing bolts -1- to 25 Nm.
Specified torque for tensioning element → Item
Further assembly is basically the reverse of the dismantling sequence.
  N13-10306

Removing and installing sealing flanges and flywheel or drive plate > < Installing