Golf Mk5
Assembly overview - intake manifold (engine codes BUD and CGGA) |
1 - | Intake manifold |
2 - | Seal |
q | Renew. |
3 - | 7 Nm |
4 - | Throttle valve module -J338- |
q | Clean → Chapter. |
q | If renewed, erase learnt values and adapt engine control unit to throttle valve module → Vehicle diagnostic tester„Guided function“ |
5 - | 20 Nm |
6 - | Hose |
q | To brake servo. |
7 - | O-ring |
q | Renew. |
8 - | Coolant hose |
q | For crankcase breather preheater |
9 - | Spring-type clip |
q | Remove and install using hose clip pliers -VAS 6340- or spring-type clip pliers -VAS 5024A- |
10 - | Crankcase breather preheater |
q | To remove and install, remove intake manifold |
11 - | 3 Nm |
12 - | Hose |
q | To oil separator with heated vacuum valve. |
13 - | Intake manifold pressure sender -G71- with intake air temperature sender -G42-. |
q | Clipped onto intake manifold. |