volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing drive plate > < Assembly overview - sealing flange on gearbox side and dual-mass flywheel/drive plate

Golf Mk5

Removing and installing dual-mass flywheel
Removing and installing dual-mass flywheel
Special tools and workshop equipment required
   
t  Counterhold tool -3067-
Removing
–  Remove gearbox → Power transmission; Rep. gr.37.
  Caution
To prevent damage to the dual-mass flywheel when removing, the bolts -B- must not be removed with an impact wrench or similar. The bolts may only be removed by hand.
  W00-0026
–  Rotate the dual-mass flywheel -A- so that the bolts -B- align centrally with the holes -arrows-.
–  When unscrewing bolts -B-, ensure that none of the bolt heads come into contact with the dual-mass flywheel -arrows-. The flywheel will otherwise be damaged when the bolts are unscrewed further.
  A30-0102
–  Insert counterhold -3067- in hole on cylinder block -B-.
–  Unscrew dual-mass flywheel.
Installing
Installation is carried out in the reverse order. When installing, note the following:
l  Specified torque → Item.
–  Use new bolts for securing.
  A13-0051
–  Insert counterhold -3067- in hole on cylinder block -A-.
  A13-0051

Removing and installing drive plate > < Assembly overview - sealing flange on gearbox side and dual-mass flywheel/drive plate