Golf Mk5
Assembly overview - exhaust system (engine code CBFA) |
1 - | 40 Nm |
q | Renew |
q | Coat studs of exhaust manifold with high-temperature paste. |
q | High-temperature paste -G 052 112 A3- |
2 - | Lambda probe 2 -G108- |
q | Bank 1, probe 2 |
q | 55 Nm |
q | The thread on new Lambda probes is coated with high-temperature paste. |
q | When re-using the old Lambda probe, coat only the thread with high-temperature paste; the paste must not get into the slots of the probe body. |
q | High-temperature paste -G 052 112 A3- |
3 - | Front exhaust pipe with catalytic converters |
Caution
|
q | Protect catalytic converter from damage by knocks and impact |
q | Removing and installing → Chapter |
q | Aligning exhaust system free of stress → Chapter. |
4 - | Lambda probe after catalytic converter -G130- |
q | Bank 1, probe 3 |
q | 55 Nm |
q | The thread on new Lambda probes is coated with high-temperature paste. |
q | When re-using the old Lambda probe, coat only the thread with high-temperature paste; the paste must not get into the slots of the probe body. |
q | High-temperature paste -G 052 112 A3- |
5 - | Rubber mounting |
q | Renew if damaged. |
6 - | Nut |
q | Tighten bolted connections evenly. Specified torque and installation position → Fig. |
7 - | Rear silencer |
q | In initial equipment, component with centre silencer. Can be renewed individually for repair purposes. |
q | Separate exhaust system → Chapter. |
8 - | Mounting |
q | Renew if damaged. |
9 - | 25 Nm |
10 - | Rear clamp |
q | For separate replacement of centre and rear silencers |
q | Tighten bolted connections evenly. Specified torque and installation position → Fig. |
11 - | Centre silencer |
q | Combined in one unit with rear silencer as original equipment. Can be renewed individually for repair purposes. |
q | Separate exhaust system → Chapter. |
12 - | 25 Nm |
13 - | Front clamp |
q | Tighten bolted connections evenly. Specified torque and installation position → Fig. |
14 - | Nut |
q | Tighten bolted connections evenly. Specified torque and installation position → Fig. |
15 - | Mounting |
q | For centre silencer. |
16 - | Mounting |
q | Renew if damaged. |
17 - | Seal |
q | Renew |
18 - | Lambda probe -G39- |
q | Bank 1, probe 1 |
q | 55 Nm |
q | The thread on new Lambda probes is coated with high-temperature paste. |
q | When re-using the old Lambda probe, coat only the thread with high-temperature paste; the paste must not get into the slots of the probe body. |
q | High-temperature paste -G 052 112 A3- |