Volkswagen Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing catalytic converters with front exhaust pipe >
< Aligning exhaust system free of stress
Golf Mk5
Power unit
4-cylinder injection engine (1.8 and 2.0 l engine, chain drive)
Exhaust system / Exhaust system (Golf, Eos, Scirocco)
Installation position and specified torque of clamp
Installation position and specified torque of clamp
Installation position and specified torque of clamp
Note
Gradual introduction of clamp with continuous clip.
Specified torque and installation dimensions of clamp
Clamp
-A-
with 2 individual clips.
Specified torque: 25 Nm.
Installation dimensions
-a-
5 mm (only for front clamp)
Clamp
-B-
with continuous clip.
Specified torque: 35 Nm.
Installation dimensions
-a-
8.5 mm (only for front clamp)
Installation dimension
-a-
for vehicles with marking on front exhaust pipe
1 -
Clamp
2 -
Front exhaust pipe
a -
Installation dimension
A -
Marking
Installation position of front clamp
–
Install clamp so that end of bolt
-arrow-
does not extend beyond lower edge of clamp.
l
Threaded connection faces right
Installation position of rear clamp
–
Install clamp so that end of bolt
-arrow-
does not extend beyond lower edge of clamp.
l
Threaded connection faces to rear.
Power unit
4-cylinder injection engine (1.8 and 2.0 l engine, chain drive)
Exhaust system / Exhaust system (Golf, Eos, Scirocco)
Installation position and specified torque of clamp
Removing and installing catalytic converters with front exhaust pipe >
< Aligning exhaust system free of stress