Golf Mk5
Part ll, assembly overview - oil pump with balancer shaft gear assembly |
1 - | Chain guard |
2 - | Chain |
q | Before removing, mark running direction (fitting position) with paint |
3 - | Dowel sleeves |
4 - | Oil pump with balancer shaft gear assembly |
q | Before installing, ensure that both dowel sleeves for centring are installed. |
q | With pressure relief valve (12 bar) |
q | Removing and installing → Chapter |
Engine codes AXW, BLX, BLY, BLR: |
q | If sump is removed, then intermediate plate must always be renewed ( → Item). |
5 - | 3 Nm |
q | Insert with locking fluid. |
6 - | Cover |
q | Prevents foam build-up in engine oil |
7 - | Oil return connection |
q | With seal. |
8 - | 9 Nm |
9 - | Oil suction pipe |
q | Clean strainer if soiled. |
10 - | 8 Nm |
11 - | O-ring |
q | Renew |
12 - | 15 Nm + 1/4 turn (90°) further |
q | Renew |
q | Note different bolt lengths → Fig.. |
13 - | Dowel sleeves |
14 - | Outer rotor |
q | Check running surfaces for scoring. |
q | Marking must be visible. |
15 - | Inner rotor |
q | Check running surfaces for scoring. |
16 - | Oil pump cover |
17 - | Sprocket |
18 - | 20 Nm + 1/4 turn (90°) further |
19 - | Chain tensioner with tensioning plate |
q | Preload when installing → Chapter. |
20 - | 15 Nm |