Golf Mk5
| Part IV |
| 1 - | Knock sensor 1 -G61- |
| q | To remove and install, the coolant distributor housing must be removed. |
| q | Gold-plated contacts |
| 2 - | 20 Nm |
| q | The specified torque influences the function of the knock sensor. |
| 3 - | Knock sensor 2 -G66- |
| q | Gold-plated contacts |
| q | To remove and install, the oil filter bracket must be removed ( → Item). |
| 4 - | Oil dipstick |
| q | The oil level must not be above the max. mark! |
| q | Markings on oil dipstick |
| 5 - | Baffle plate |
| 6 - | Gasket |
| q | Renew |
| 7 - | Oil filter bracket with attachments |
| q | Removing and installing → Chapter |
| 8 - | 15 Nm |
| 9 - | 10 Nm |
| 10 - | Engine speed sender -G28- |
| 11 - | Seal |
| q | Renew |
| 12 - | Rubber bush |
| q | 3 Nm |
| 13 - | Intake manifold support |
| 14 - | 25 Nm |
| 15 - | 40 Nm |
| 16 - | Coolant distributor housing |
| q | Removing and installing → Chapter |
| 17 - | 15 Nm |
| 18 - | O-ring |
| q | Renew |
| 19 - | 45 Nm |
| 20 - | Ancillary bracket |
| q | Observe tightening sequence → Fig.. |
