volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing plate sealing flange > < Removing and installing crankshaft sealing flange - flywheel end

Golf Mk5

Removing and installing aluminium sealing flange
Removing and installing aluminium sealing flange
Special tools and workshop equipment required
   
t  Fitting tool -T10122-
Removing sealing flange
–  Remove gearbox → Rep. Gr.34.
–  Remove flywheel or drive plate as applicable.
–  Remove sump.
   Engine codes AXW, BLX, BLY, BLR → Chapter.
   Engine codes BVX, BVY, BVZ → Chapter
  W00-1234
–  Unbolt sealing flange -arrows-.
Installing sealing flange
Features of aluminium sealing flange:
t  Centring pins necessary in cylinder block
t  Sealing lip towards engine
t  Bolts longer than in case of plate sealing flange
  Note
t  Do not additionally oil or grease the oil seal sealing lip.
t  If an aluminium sealing flange is installed in place of a plate sealing flange, insert centring pins and use longer bolts → ETKA (Electronic parts catalogue).
–  Clean sealing surfaces. They must be free of oil and grease.
–  Remove oil residue from end of crankshaft journal using clean cloth.
–  Assemble fitting tool sleeves -T10122/1- and -T10122/2-.
  N13-10128
–  Push sealing flange -A- with outer side onto fitting tool sleeves.
–  Separate fitting sleeves.
  N13-10127
–  Set sealing flange -A- with fitting tool sleeve -T10122/2- on crankshaft and push sealing flange onto crankshaft journal.
  N13-10126
–  Tighten securing bolts to 15 Nm -arrows-.
–  Install sump.
   Engine codes AXW, BLX, BLY, BLR → Chapter.
   Engine codes BVX, BVY, BVZ → Chapter.
Further assembly is basically the reverse of the dismantling procedure.
  N13-10128

Removing and installing plate sealing flange > < Removing and installing crankshaft sealing flange - flywheel end