Golf Mk5
Assembly overview - intake manifold |
1 - | Vacuum hose |
q | Check for secure seating. |
2 - | Vacuum reservoir |
3 - | 10 Nm |
4 - | Exhaust gas recirculation pipe |
q | Only on vehicles with exhaust gas recirculation system |
5 - | Vacuum hose |
q | With non-return valve |
q | Check for secure seating. |
6 - | Crankcase breather hose |
7 - | Seal |
q | Renew if damaged. |
8 - | Cable retainer |
9 - | 8 Nm |
10 - | Throttle valve control module -J338- |
q | Engine codes AXW, BLX, BLY, BLR: heated by coolant |
q | With throttle valve drive for electric throttle -G186-, throttle valve drive angle sender 1 for electric throttle -G187- and throttle valve drive angle sender 2 for electric throttle -G188-. |
q | Clean → Chapter. |
q | Adapt throttle valve module -J338- to engine control unit → Vehicle diagnosis, testing and information system VAS 5051“Guided functions” |
11 - | Connection for suction-jet pump |
q | Assembly overview - suction-jet pump → Chapter. |
12 - | Seal |
q | Renew if damaged. |
13 - | Intake manifold pressure sender -G71- with intake air temperature sender -G42- |
14 - | 3 Nm |
15 - | O-ring |
q | Renew if damaged. |
16 - | 10 Nm |
17 - | Bonded rubber mounting |
18 - | Intake manifold support |
19 - | 25 Nm |
20 - | 40 Nm |
21 - | Seal |
q | Renew if damaged. |
22 - | Seal |
q | Renew if damaged. |
23 - | Change-over barrel |
24 - | 7 Nm |
25 - | Cover |
26 - | Variable intake manifold change-over valve -N156- |
27 - | Vacuum unit |
q | Checking → Chapter |
28 - | Intake manifold |
q | Removing and installing → Chapter |
29 - | Connection for activated charcoal filter system solenoid valve 1 -N80- |
q | Assembly overview - activated charcoal filter system |