–
| Tension toothed belt. To do so, turn hexagon key at the eccentric adjuster clockwise (direction of arrow) until the notch is above the indicator (toothed belt over-tensioned). |
–
| Then release tension on toothed belt. |
–
| Now tension toothed belt until the notch and the indicator are aligned. |
–
| Tighten securing nut to 25 Nm. |
–
| Turn crankshaft two turns in engine direction of rotation until engine is again at TDC. It is important that the last 45° rotation (1/8 turn) is performed without interruption. |
–
| Check toothed belt tension. Specification: indicator and notch must align. |
|
|
|