volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing toothed belt > < Installing cylinder head

Golf Mk5

Removing and installing toothed belt, vehicles without split toothed belt guard
Removing and installing toothed belt, vehicles without split toothed belt guard
  Note
Vehicles as of 01/2006 have a new toothed belt guard. Identification: the upper part of the toothed belt guard has no cover → Item and the toothed belt guard is split in the area of the engine bracket. Removing and installing toothed belt, vehicles with split toothed belt guard → Chapter.
   
Special tools and workshop equipment required
t  Bracket -T10339-
t  Wing compensation plate -T40045- only Golf
t  Adapter -10 - 222 A /18- only Golf and Eos
t  Rack -10 - 222 A /1-
t  Support bracket -10 - 222 A-
t  Torque wrench -V.A.G 1332-

  Note
To remove engine bracket, lift engine a considerable amount with support bracket -10-222A-. Disconnect drive shafts from gearbox to prevent damage through extreme bending angles.
Removing toothed belt → Chapter.
Installing toothed belt → Chapter.
   

Removing toothed belt > < Installing cylinder head