Golf Mk5
Part 2 |
1 - | Chain guard |
2 - | Chain |
q | Before removing, mark running direction (installation position) with paint. |
3 - | Dowel sleeves |
4 - | Intermediate plate |
5 - | Oil pump with balancer shaft gear assembly |
q | Before installing, ensure that both dowel sleeves for centring are installed. |
6 - | 9 Nm |
7 - | Cover |
q | Prevents foam build-up in engine oil. |
8 - | 40 Nm |
9 - | 8 Nm |
10 - | Oil suction pipe |
q | Clean strainer if soiled. |
11 - | O-ring |
q | Renew. |
12 - | 15 Nm + 1/4 turn (90°) further |
q | Renew. |
q | Note different bolt lengths → Fig.. |
13 - | Outer rotor |
q | Check running surfaces for scoring. |
q | Marking must be visible. |
14 - | Inner rotor |
q | Check running surfaces for scoring. |
15 - | Oil pump cover |
16 - | Chain sprocket |
17 - | 20 Nm + 1/4 turn (90°) further |
q | Renew. |
18 - | Chain tensioner with tensioning plate |
q | Preload when installing → Chapter. |
19 - | 15 Nm |