–
| Remove oil pressure switch -F1- → Chapter and screw it into tester. |
–
| Screw tester into oil filter bracket in place of oil pressure switch. |
–
| Connect test instrument/DSO adapter (2-pin) -VAS 5256- to oil pressure switch |
–
| Connect Multimeter -V.A.G 1526D- to test instrument/DSO adapter (2-pin) -VAS 5256- and check for continuity. |
l
| Oil pressure switch must be open below 1.2 bar. |
–
| Start engine and increase engine speed. At 1.2…1.6.bar, the oil pressure switch must close, otherwise renew oil pressure switch. |
–
| Increase engine speed further. At 2000 rpm and an oil temperature of 80 °C the oil pressure should be between 2.7…4.5 bar. |
At higher engine speeds, the oil pressure must not exceed 7.0 bar. |
If specification is not attained: |
–
| Check strainer in oil suction pipe for contamination/soiling → Item. |
Note Mechanical damage, e.g. to bearings, could also be the cause for oil pressure being too low. |
–
| Renew oil pump and balancer shaft gear assembly → Chapter. |
If the specification is exceeded: |
–
| If necessary, renew oil filter bracket with pressure relief valve. |
|
|
|