Volkswagen Workshop Service and Repair Manuals > Golf Mk5 > Power unit | 4-cylinder injection engine (2.0 l engine, turbocharger) | Engine lubrication | Parts of lubrication system | Removing and installing oil pressure switchF1

Removing and installing oil pressure switchF1

Removing and installing oil pressure switch -F1-

Special tools and workshop equipment required

t	Jointed wrench 24 mm -T40175-

Removing:

–	Remove noise insulation → General body repairs, exterior; Rep. gr.50

–	Remove left charge air pipe -item 1 and 2-.

–	Remove electrical connector -1- from retainer and pull connector -arrow- off oil pressure switch.

Vehicles with a single pin oil pressure switch:

–	Unscrew bolt -B- for earth line (ignore arrows).

All vehicles:

–	Unscrew oil pressure switch with 24 mm articulated wrench -T40175-

Installing:

–	Insert oil pressure switch by hand and tighten to 20 Nm.

Note

For single pin oil pressure switch, check earth wire is connected.

Further assembly is basically the reverse of the dismantling sequence.

Volkswagen Workshop Service and Repair Manuals