Volkswagen Workshop Service and Repair Manuals

Removing and installing accelerator module Special tools and workshop equipment required

t  For left-hand drive vehicles: Release tool -T10238- or

t  For right-hand drive vehicles: Release tool -T10240- Removing

–  Remove steering column cover -arrows-.

–  Prise out cap -3- using a screwdriver. –  Remove securing bolt -2-. –  Release connector -1--arrow- and pull off accelerator module.

–  Push release tool -T10238- into holes as shown to stop and remove accelerator module. Installing

–  Reconnect connector -1- to accelerator module -4-. Lock connector -arrow-. –  Press accelerator module onto securing pins -5-. –  Insert centring pin -6- into hole in floor of vehicle. –  Secure accelerator module with bolt -2- and install cap -3-.

–  Install steering column trim. Specified torque:

Component		Nm
Accelerator module to body		10