volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Assembly overview - fuel rail (vehicles from 05.2006) > < Removing and installing intake manifold flap motorV157 and intake manifold flap potentiometerG336

Golf Mk5

Assembly overview - fuel rail (vehicles up to 05.2006)
Assembly overview - fuel rail (vehicles up to 05.2006)
  WARNING
Observe safety precautions when releasing fuel pressure in high-pressure section → Chapter
   
1 - Injector, cylinder 1 -N30- through injector, cylinder 4 -N33-
q   Removing and installing → Chapter.
2 - 8 Nm
3 - Fuel rail
q   Removing and installing → Chapter.
4 - Panel nut
5 - Pressure limiting valve
q   30 Nm
q   To remove and install, remove intake manifold → Chapter.
6 - Low pressure pipe
q   When removing, counterhold pressure limiting valve
q   Before installing, check pressure of pressure limiting valve.
q   Install free of tension.
q   Tighten union nut to 22 Nm.
7 - Bracket
8 - High-pressure pipe
q   Install free of tension.
q   Tighten high-pressure pump union nuts to 27 Nm.
q   Tighten fuel rail union nuts to 33 Nm.
9 - Connector
q   For injectors.
10 - 5 Nm
11 - Fuel pressure sender -G247-
q   22 Nm
q   Coat thread and sealing taper with clean engine oil.
q   Removing and installing → Chapter.
q   Check → Chapter.

   

Assembly overview - fuel rail (vehicles from 05.2006) > < Removing and installing intake manifold flap motorV157 and intake manifold flap potentiometerG336