Volkswagen Workshop Service and Repair Manuals

Pulling needle bearing out of and driving into crankshaft Only vehicles with a dual clutch gearbox Special tools and workshop equipment required

t  Counter support e. g. Kukko -22/1-

t  Internal puller e.g. Kukko -21/2-

t  Drift -VW 207 C-

Removing: –  Remove needle bearing using a standard pulling tool e. g. Kukko -21/2- and counter support e.g. Kukko -22/1--A-.

Installing:   Note The lettering on the needle bearing must be visible when installed. –  Drive in needle bearing with drift -VW 207 C-.

Installation depth: dimension -a- = 1.5 mm.