| Adapting the navigation system after installing a new unit |
| When a new radio navigation system has been installed the system must be calibrated and matched to the vehicle. |
| –
| During normal operation of radio navigation system press button MEN twice, the unit then switches to the setup menu. |
| –
| Select “INSTALLATION” in setup menu. |
| –
| Select menu item “Calibration”. |
| –
| Select menu item “NEWUNIT”. |
| –
| Press the right rotary/push knob. |
| You will be guided through the installation on the display. |
| Follow the instructions from the unit. The unit will first carry out a system test. |
| –
| Perform the operating steps requested by the system and then press the right rotary/push knob. |
| After the system test the system automatically performs the actual calibration. To do this a distance of 8-15 km (5-10 miles) must be driven with good GPS reception. |
| Before commencing the drive the system will request conformation that any existing old calibration values have been erased. |
Note | t
| After selecting “NEWUNIT” no objective guide is possible during the first 25 % of the calibration procedure. |
| t
| The distance to be driven is dependent on various factors, like the quality of the GPS reception and the route. The distance given is simply a mean value. It can be distinctly less or if conditions are poor distinctly longer. |
|
|
|
