t
| CALIB. = shows the number of faults occurred |
t
| SENSOR = shows the number of faults occurred |
t
| INTERNAL = shows the number of faults occurred |
t
| CD DRIVE = shows the number of faults occurred |
t
| QUIT = by confirming the menu item with “CLEAR” the fault memory will be cleared. |
After selecting this menu item it can take up to 10 seconds before the test results are displayed. |
Explanation of possible faults: |
t
| CALIB. = “ERROR” means that a fault has occurred during calibration. |
t
| SENSOR = “GPS” means that there is a reception problem or no communication with the GPS module. “GAL” means that there is a fault in the speed dependent volume control (GALA). “R” means that the reversing light signal was not recognised. |
t
| INTERNAL = “ERROR” means that a fault has occurred in the gyro compass or in the GPS receiver. |
t
| CD DRIVE = “CD” means that a fault has occurred when reading the CD. “TEMP” means that the temperature in the CD drive is too high. |
Note A fault will only be displayed when the fault state is active at the time of interrogating and a given number for the frequency of this fault has been exceeded in the internal fault counter. |
|
|
|