volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Renewing side light bulb > < Renewing headlight dipped beam bulb
Renewing headlight main beam bulb
Renewing headlight main beam bulb
  Note
The diagrams show renewal of the headlight main beam bulb for the left headlight.
Removing:
–  Switch off ignition and all electrical consumers and remove ignition key.
   
–  Remove cover cap -1-.
  N94-10179
–  Pull off multi-pin connector -1-.
  N94-10180
–  Push retaining clip -2- in direction of -arrow- under locking lugs -1- and lift up retaining clip -2-.
  N94-10181
–  Take headlight main beam bulb-1- out of headlight.
Installing:
  Caution
When installing cover cap, ensure cap is seated correctly. The ingress of water will lead to permanent damage to the headlight.
  Note
Do not touch bulb glass when fitting bulbs. Fingers leave traces of grease on the glass, which evaporate when the bulb is switched on and cause the glass to cloud over.
Installation is carried out in the reverse order. When installing observe the following:
  N94-10182
–  Place headlight main beam bulb-1- in recesses -arrows- of headlight.
–  Check headlight functions.
–  Check headlight setting and adjust headlight as necessary → Booklet38.
  N94-10182

Renewing side light bulb > < Renewing headlight dipped beam bulb