volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing headlight range control motor > < Renewing side light bulb

Golf Mk5

Renewing front turn signal bulb
Renewing front turn signal bulb
  Note
The following illustrations show the renewal of the front turn signal bulb for the left headlight.
Removing:
–  Switch off ignition and all electrical consumers and remove ignition key.
   
–  Remove cover cap -1-.
  N94-10268
–  Turn bulb holder -1- with front turn signal bulb in direction of -arrow- and remove from reflector (be careful not to stretch wiring).
  N94-10271
–  Push front turn signal bulb-2- down in bulb holder -1- and turn front turn signal bulb-2- in direction of -arrow-.
–  Pull front turn signal bulb-2- out of bulb holder -1-.
Installing:
  Caution
When installing cover cap, ensure cap is seated correctly. The ingress of water will lead to permanent damage to the headlight.
  Note
Do not touch bulb glass when fitting bulbs. Fingers leave traces of grease on the glass, which evaporate when the bulb is switched on and cause the glass to cloud over.
Installation is carried out in the reverse order. When installing observe the following:
–  Check headlight functions.
  N94-10272

Removing and installing headlight range control motor > < Renewing side light bulb