volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Removing and installing windscreen washer system spray jets > < Removing and installing windscreen and rear window washer pumpV59
Removing and installing windscreen washer fluid level senderG33
Removing and installing windscreen washer fluid level sender -G33-
  Note
Depending on vehicle equipment, fitting location of windscreen washer fluid level sender -G33- may slightly deviate from illustrations. Removal procedure is analogue.
Removing:
–  Switch off ignition and all electrical consumers and remove ignition key.
–  Remove front bumper cover → General body repairs, exterior; Rep. gr.63.
   
–  Unplug connector -1- at windscreen washer fluid level sender -G33-.
–  Pull windscreen washer fluid level sender -G33--2- out of its rubber seal.
–  Drain any escaping fluid in a suitable container.
Installing:
Install in the reverse order of removal. When doing this, note the following:
–  On completion of installation work, bleed headlight washer system → Chapter.
  N92-10204

Removing and installing windscreen washer system spray jets > < Removing and installing windscreen and rear window washer pumpV59