Volkswagen Workshop Service and Repair Manuals > Golf Mk5 > Vehicle electrics | Electrical system | Wiring | Control units | Convenience system central control unitJ393 | Removing and installing convenience system central control unitJ393

Removing and installing convenience system central control unitJ393

Removing and installing convenience system central control unit -J393-

Removing:

–	Switch off ignition and all electrical consumers and remove ignition key.

–	Remove glove compartment → General body repairs, interior; Rep. gr.68.

–	Pull locking lug -1- of retainer for convenience system central control unit -J393- in -direction of arrow- and push convenience system central control unit -J393- until recesses -2- are positioned over recesses -3-.

Note

The connectors can only be released and disconnected once the recesses -arrows- of the connector and bracket are aligned with each other precisely.

–	Release connector and pull connector off central convenience system control unit -J393-.

Note

The number of connectors depends on the vehicle equipment level.

–	Remove securing nuts -arrows-.

–	Remove bracket with central convenience system control unit -J393-.

–	Pull retaining lug -1- in -direction of arrow B- and push central convenience system control unit -J393--2- in -direction of arrow A- out of bracket.

Installing:

Installation is carried out in the reverse order. When installing observe the following:

Note

t	If a new convenience system central control unit has been installed, it must be coded → Chapter.

t	The connectors can only be plugged in and locked once the recesses -arrows- of the connector and bracket are aligned with each other precisely.

Volkswagen Workshop Service and Repair Manuals