Volkswagen Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing engine speed sender >
< Removing and installing automatic glow period control unit
Golf Mk6
Power unit
4-cylinder diesel engine (2.0 l engine, common rail, generation II)
Ignition system, glow plug system / Glow plug system
Removing and installing Hall sender
Removing and installing Hall sender
Removing and installing Hall sender
Fitting location
→ Item
–
Remove noise insulation
→ General body repairs, exterior; Rep. gr.66
.
–
Remove toothed belt
→ Chapter
.
–
Release and disconnect connector
-1-
from Hall sender -G40-.
–
Unclip connector on the water pipe.
–
Screw off Hall sender -G40-
-arrow-
.
–
Remove webs and repair aperture cover
-arrows-
with a screwdriver.
–
Remove Hall sender -G40- from cylinder head and insert its connector through repair hole in toothed belt guard.
Installing
Install in reverse order. In the process, note the following:
t
Seal repair aperture in toothed belt guard with rubber plugs as specified in
→ Electronic parts catalogue (ETKA)
.
–
Install toothed belt
→ Chapter
.
Specified torque
Component
Specified torque
Hall sender -G40- on the cylinder head
10 Nm
Power unit
4-cylinder diesel engine (2.0 l engine, common rail, generation II)
Ignition system, glow plug system / Glow plug system
Removing and installing Hall sender
Removing and installing engine speed sender >
< Removing and installing automatic glow period control unit