Golf Mk6
Assembly overview: wheel bearing housing, trailing arm (front-wheel drive) |
1 - | Bolt |
q | 50 Nm + 45° further |
q | Always renew after removing. |
2 - | Mounting bracket |
3 - | Bolt |
q | 90 Nm + 90° further |
q | Always renew after removing. |
4 - | Coupling rod |
q | Connects anti-roll bar to trailing arm and wheel bearing housing |
5 - | Bolt |
q | 90 Nm + 45° further |
q | Observe tightening sequence → |
q | Always renew after removing. |
6 - | Trailing arm |
q | Removing and installing → Chapter. |
q | Repairing → Chapter |
7 - | Bolt |
q | 8 Nm |
8 - | Rear right speed sensor -G44-/rear left speed sensor -G46- |
q | Can be tested in guided fault finding using → Vehicle diagnostic tester |
q | Before inserting sensor, clean inner surface of hole and coat with lubricating paste -G 000 650-. |
9 - | Wheel bearing housing |
q | Removing and installing → Chapter. |
10 - | Bonded rubber bush |
q | Renewing → Chapter. |
11 - | Nut |
q | 45 Nm |
q | Always renew after removing. |
12 - | Bolt |
q | 4 Nm |
13 - | Brake disc |
14 - | Dust cap |
q | Always renew after removing. |
q | Pressing off and driving in → Chapter |
A proper seal can be achieved only by installing a new grease cap. |
15 - | Bolt |
q | 180 Nm + 180° further |
q | Loosen and tighten with bit XZN 18 -T10162- |
q | Always renew after removing. |
16 - | Wheel hub with wheel bearing |
q | ABS sensor ring is installed in wheel bearing. |
q | Removing and installing → Chapter. |
The wheel bearing and wheel hub are assembled in one housing. |
This wheel bearing/wheel hub unit is maintenance-free and has zero play. Adjustments and repairs are not possible! |
17 - | Bolt |
q | 12 Nm |
18 - | Splash plate |