–
| Check circumferential rubber seal -1- of swivel badge and ensure that it is completely inserted in groove. |
–
| Insert drain hose on hose nozzle on underside of swivel badge. |
–
| Fit swivel badge into rear lid. |
–
| Lock swivel badge by turning it to left into its mounting in rear lid. |
–
| Screw in the three securing nuts of swivel badge without tightening them. |
–
| Centre swivel badge on body aperture in rear lid and tighten the three securing nuts to 4 Nm. |
–
| Connect all connectors of reversing camera wiring harness and secure all wires and connectors with wire retainers to avoid rattling. |
–
| After installation, clean reversing camera lens with a lint-free cloth. |
|
|
|