Golf L4-1.8L Turbo (AWW) (2003)
-
Check wiring for open circuit between test box and connector using
-
Wiring diagram.
Contact 1+socket 98
Contact 2+socket 86
Contact 3+socket 108
Wire resistance: Max. 1.5 Ohm
-
Additionally check wires for short to one another.
If no wiring fault is detected and voltage was present between contacts 1+3:
-
Replace Camshaft Position (CMP) sensor 2 (G40).
-
Check DTC Memory, if necessary, repair any malfunctions and then Erase DTC Memory, Checking and Erasing DTC Memory. Refer to
"Displaying and Reading Trouble Codes/With Manufacture Scan Tool/Check DTC Memory (Function 02)" See: Testing and Inspection
-
Read readiness code. If DTC memory has been erased or engine control module was disconnected from permanent positive, readiness code must
be generated again: Refer to "Monitors, Trips and/or Drive Cycle/ Reading Readiness Code" See: Testing and Inspection
Engine code AWW. Refer to "Monitors, Trips and/or Drive Cycle/Generating Readiness Code" See: Testing and Inspection
Engine code AWP. Refer to "Monitors, Trips and/or Drive Cycle/Generating Readiness Code" See: Testing and Inspection
If no wiring fault is detected and no voltage was present between contacts 1+3:
-
Replace engine control module.