Golf L4-1.8L Turbo (AWW) (2003)
-
Reinstall relay carriers, secure with (2) nuts -A- and tighten to 2 Nm (18 in. lbs.)
-
Insert the connector -11- (contains terminal removed from B+ fuse connector at the start of this procedure) to connector -2- (arrow) on the new
wire harness assembly
-
Reinstall fuse holder to location -B- on the lower relay block
-
Reinstall 15 amp fuse
-
Reinstall fuse/relay holders -A- & -C- into proper location on lower relay block
-
Locate ground (GND) wire -6- (eyelet terminal on the new wiring harness assembly)
-
Remove cap nut at ground point -arrow- near steering column, install ground wire eyelet -6- from new harness assembly, secure with cap nut and
tighten to 6 Nm (53 in. lbs.)
-
Install new (141 951 253 B) relay into upper relay block position 9 -arrow-
-
Reinstall instrument panel lower cover
-
Reinstall reinforcement and secure with (6) screws