Golf L4-1.8L Turbo (AWW) (2003)
Axle Beam: Service and Repair
Rear Axle Beam, Assembly Overview
Rear axle beam, assembly overview
Note:
Welding and straightening on axle beam and stub axle is not permissible.
^
Always replace self-locking nuts.
1. Wheel bolt, 120 Nm (89 ft. lbs.)
2. Phillips-head screw
3. Brake disc
4. Dust cap
^
Replace each time after removing
A perfect seal is only achieved using a new dust cap.
Only then is possible an optimum function and long service life guaranteed.
5. Self-locking 12-point nut, 175 Nm (129 ft. lbs.)
^
Replace each time after removing
6. Wheel hub with wheel bearings
The wheel bearing and wheel hub are installed together in a housing.
This wheel bearing/hub unit is maintenance and adjustment free. Adjusting and servicing is not possible!
7. Hex head bolt, 60 Nm (44 ft. lbs.)