Golf L4-1.8L Turbo (AWW) (2003)
-
Remove flange shaft cone-head bolt.
-
Remove flange shaft with spring.
-
Pull out seal.
Notes:
-
Do not damage sleeve, otherwise leaks Will occur.
-
Replace sleeve if damaged. Refer to Case, M/T.
Installing
-
Drive seal into sleeve onto stop. Do not tilt seal.
-
Fill space between sealing lips with G 052 128 A1 grease.
-
Insert flange shaft.
-
Install cone-head bolt into flange shaft threaded piece.
-
Install left-hand drive shaft or attach right-hand drive shaft to flange shaft.
-
Install drive shaft protective cover if necessary.