Golf L4-1.8L Turbo (AWW) (2003)
^
Drive new seal in onto stop, do not tilt seal when doing this.
^
Fill space between sealing lip and dust lip with grease G052 128 A1.
^
Insert flanged shaft.
^
Secure flange shaft with countersunk bolt and tighten to specified torque.
^
Install drive shaft.
^
Connect ball joint to control arm using new bolts at old impression marks
^
Install wheel.
^
Check transmission oil.
^
Install sound insulation tray.
Tightening torques
Flanged shaft to transmission (conical head bolt) ....................................................................................................................................................... 25 Nm