Golf L4-1781cc 1.8L SOHC (ACC) Can (1993)
Caliper Piston Removing
1. Force piston out of caliper housing with compressed air.
CAUTION: Place a wooden block in the caliper to prevent damage to the piston.
WARNING: Use only enough air pressure to force the piston out.
Caliper Seal Removing
2. Carefully remove piston seal using modified tool No. VAG 1474/5, or equivalent, refer to procedures below.
CAUTION: When removing, use care to ensure that the cylinder bore is not damaged.
Modifying Wedge Tool No. VAG 1474/5
-
Reshape wedge point size in area -a-.
Width -b- = 6 mm (1/4 inch)
-
Reshape wedge point to length -c-.
Length -c- = 10 mm (3/8 inch)
-
Remove burrs from point of modified wedge.
Installation
Piston Dust Seal Installing