Golf L4-1781cc 1.8L SOHC (ACC) Can (1993)
Fig. 4
Fig. 4 Placing inner and outer plates on inner plate carrier and installing support ring
- Insert thrust plate and inner and outer plates, then install supporting ring (-arrow-).
Note:
An inner and an outer plate must be placed in clutch housing before inserting inner plate carrier
Fig. 5
Fig. 5 Installing pressure plate, first inner and first outer plates in clutch housing
Fig. 6
Fig. 6 Inserting inner plate carrier and installing circlip (-arrow-).
- Lift inner plate carrier slightly to install circlip.
Fig. 7
Fig. 7 Checking that piston rings are correctly located
- There are two piston rings installed on turbine shaft inside clutch housing.
- Make sure that ends of piston rings are hooked together.