Golf L4-1781cc 1.8L SOHC (ACC) Can (1993)
-
Open hose clamp
-
Open clamp on shaft small end and push back boot.
-
Drive screwdriver or similar tool into cover and pry open.
NOTE:
-
If the cover will not pry open, insert screwdriver and pry from the opposite side.
-
The cover is destroyed in the removal process. It does not need to be replaced.
-
Remove O-ring -arrow- from groove.
-
Mark installation positions of parts -1-, -2- and -3-.
1- Triple-rotor joint housing
2- Triple-rotor star
3- Axle shaft
NOTE:
-
Noises while driving may result if the indicated parts are not reassembled to their prior positions.
-
Use a waterproof felt-tipped pen for marking parts.
-
Remove rubber gasket (arrow) from groove.
-
With triple-rotor joint housing clamped in vise, pull axle shaft together with triple-rotor star upward out of housing.
CAUTION: Do not let the rollers slide off the triple-rotor star and fall to the floor.
-
Hold axle shaft in straight alignment to triple-rotor joint and slowly push back triple-rotor joint housing with other hand.