Golf L4-1896cc 1.9L DSL Turbo (1Z) (1997)
-
Pull new oil seal in up to stop with press piece 3319, 10 mm threaded rod (approx. 80 mm or 3 1/4 inch long) and nut with washer.
-
Fill space between seal and dust lip with multi-purpose grease.
-
Install drive flange, dished washer and circlip.
-
Pull drive flange in.
NOTE: Drive flange can also be pulled in with VW 391.
-
Install circlip and seal drive flange with cover.
-
Install drive shaft.
-
Reconnect ball joint to control arm.
-
With transmission installed, check final drive oil level, refer to Checking Oil Level.
-
Tighten the following components to:
Drive shaft to drive flange: 45 Nm (33 ft lb)
Ball joint to control arm: 35 Nm (26 ft lb)