Golf L4-1896cc 1.9L DSL Turbo (1Z) (1997)
-
Mark installation position of rollers -1- on triple-rotor star -2- using felt-tipped marker.
-
Remove rollers and place on clean surface.
-
Remove circlip.
1- Pliers - Commercially available
-
Press triple-rotor star off axle shaft.
-
Pull triple-rotor joint housing off axle shaft.
-
Clean shaft and triple-rotor joint housing.
Assembling
-
Slide small diameter boot clamp onto shaft.
-
Slide triple-rotor joint boot onto shaft.
-
Slide triple-rotor joint housing onto shaft.
Mounting Triple-Rotor Star