Golf L4-2.0L (ABA) (1996)
Fig. 2
Fig. 2 Installing valve body with wiring harness
Fig. 3
Fig. 3 Installing valve body with conductor strip
- Route conductor strip as illustrated, when installing do not kink or twist.
Fig. 4
Fig. 4 Adjusting operating rod for manual selector valve
-
Move selector shaft to position "P".
- Push operating rod with manual selector valve into valve body as far as stop (in direction of arrow) and tighten bolt.
- Tightening torque: 4 Nm (35 in lb)
Note:
- The manual selector valve must always be resting against the stop. Counter-hold in direction of arrow when tightening bolt.
- Always replace manual selector valve bolt.