Golf L4-2.0L (ABA) (1996)
DO NOT perform procedure if the electrical connector receptacle is made of aluminum.
DO NOT perform procedure if EPROM level of Digimat 2.1 TCM is above 4066.
Resistor wire, installing
-
Disconnect 68 pin connector from TCM.
-
Out tie wrap at end of connector and remove cover from connector by depressing tab with small screwdriver while pushing cover in direction of
-arrow-.
-
Locate cavity 50 of TCM connector -arrow- (cavity should be empty).
CAUTION!
Part numbers are for reference only. Always check with your Parts Dept. for the latest parts information.