Golf L4-2.0L (ABA) (1996)
19
Plastic ring
-
Attach to eccentric adjuster
20
Shift lever
-
Remove eccentric adjuster before removing, refer to Fig. 2, below
-
Assemble before installation
Slide on retainer plate -4-, spring -13- and ball -12- and secure with spring pin -16-
21
Selector rod
-
Extract from gearshift housing along with shift lever, refer to Fig. 3, below.
22
Selector rod support
-
When installing make sure that the two spherical halves do not separate
23
Cover plate
24
Shift boot
-
Removing, refer below.
-
Installation, refer to "Shift Lever and Shift Lever Boot". See: Shift Lever and Shift Lever Boot
25
Rubber ring
-
Vehicles with leatherette boot only
26
Shift knob
Fig. 1 Installation position of retainer plate
-
The shoulder on the periphery -arrow- is located opposite the ball
Fig. 2 Removing eccentric adjuster
-
Loosen bolt -B- and carefully pry eccentric adjuster-A- from lower section with screwdriver.
Fig. 3 Extracting selector rod with shift lever from gearshift housing
REMOVAL
-
Unscrew shift knob from shift lever and remove along with boot.