Golf L4-2.0L DSL Turbo (CJAA) (2010)
Ambient Light Sensor: Service and Repair
Rain/Light Recognition Sensor
The rain/light recognition sensor is designed so that it can be used again. The only requirement to use it again is that the connecting pad must not be
damaged.
CAUTION!
Store the removed Rain/Light Recognition Sensor protected from dust and make sure that the silicon connecting pads are not soiled up
until reinstallation.
‹› If the rain sensor was replaced by another rain sensor having a different part number, then it is necessary to code the new rain sensor. Refer to => [
Rain/Light Recognition Sensor, Coding ] See: Testing and Inspection.
‹› Rain sensors cannot be interchanged. Be sure to use the correct rain sensor.
Removing:
-
Switch off ignition, switch off all electrical consumers and remove ignition key.
-
Remove rearview mirror.
-
Disconnect electrical connection - A - from Rain/Light Recognition Sensor - 1 -.
-
Pry the Rain/Light Recognition Sensor - 1 -with a suitable screwdriver at the cut-out - 3 - from the retaining plate - 2 -.