Golf L5-2.5L (CBUA) (2010)
/Page-297002.png)
-
Look through the threaded hole and check whether the bore - 2 - in the crankshaft aligns with the threaded hole.
Use a mirror to do so.
-
Rotate the crankshaft slightly if necessary.
-
If the hole and bore align, install the (T40069) completely into the threaded hole and tighten it to 10 Nm.
‹› With the engine removed, the TDC mark can also be seen on the belt pulley and sealing flange, belt pulley side. Notches - A and B - must align.
-
Check whether the crankshaft can be rotated.
After Disassembly and Assembly Work
-
Remove the (T40069) and install the locking bolt - 1 - to the rear of the cylinder block.
