Golf GL L4-2.0L (AEG) (2001)
^
This switch can be identified by the larger (approx. 10 mm) plunger tip and square shaft (arrow).
-
Remove brake switch by turning left 90°
Install revised switch Part No: 1J0 945 511D
(see Brake switch, Part No: 1J0 945 511D:
Installing below).
Brake switch, Part No: 1J0 945 511B, C or D, removing:
^
These switches can be identified by the smaller (approx. 4 mm) plunger and round shaft (black arrow).
-
Remove brake switch by turning left 45°
When replacing after removal, install revised switch Part No: 1J0 945 511D (see Brake switch, Part No: 1J0 945 511 D: Installing below).
2.
Brake switch, Part No: 1J0 945 511 D:
Installing:
CAUTION!
This version switch contains an internal switch which can be damaged if not installed and adjusted properly.
DO NOT depress plunger prior to installation.