Golf GL L4-2.0L (AEG) (2001)
Impact Sensor: Service and Repair
Crash Sensor For Driver Side/Passenger Side Curtain Protection, Removing and Installing
Crash Sensor For Driver Side/passenger Side Curtain Protection, Removing And Installing
NOTE:
-
Removal and installation is described for left side of vehicle. same instructions apply for removal and installation for right-hand side.
-
Observe notes regarding coding in radio operators manual before disconnecting battery.
-
After connecting battery, vehicle options (radio, clock, electric window regulator) must be checked according to repair manual and/or user manual.
Removing
-
Switch ignition off.
-
Disconnect battery Ground (GND) strap.
-
Remove driver/passenger seat.
CAUTION: Observe safety precautions for working on airbags.
-
Remove floor carpet - 4 - and insulation mat in sensor area.
CAUTION: Electrostatic charges may result in involuntary deployment of airbag. Therefore, mechanic must be electrostatically
discharged before disconnecting ignition- and Ground (GND) wires. This is done e.g. by briefly grasping chassis or door striker.
-
Disconnect harness connector - 2 - and unscrew two bolts - 3 - (6 Nm).