Golf GL L4-2.0L (AEG) (2001)
-
Install sound insulation tray.
Tightening torques
Flanged shaft to transmission 25 Nm (conical head bolt)
Drive shaft to flanged shaft:
Refer to Drive Axles, Bearings and Joints.
Selector Shaft Seal, Replacing
Selector shaft seal, replacing
Special tools and equipment
-
T10090 Thrust piece
-
V.A.G 1331 Torque wrench
-
Check whether a coded radio is installed. If so, obtain anti-theft coding.
-
Switch ignition off and disconnect battery Ground strap.
-
Install battery.
-
Remove battery carrier.
-
Shift selector lever into "P" position.
-
Remove nut -arrow-.
-
Remove lever -1- from selector shaft.
-
Disconnect multi-function switch connector -2-.
-
Remove multi-function switch (F125) -3-.