Golf GL L4-2.0L (AEG) (2001)
6. Hex nut, 20 Nm
7. Dished washer
8. Lever
-
For selector shaft
9. Bolt, 6 Nm
10. Multifunction switch -F125
-
Removing, installing, adjusting
-
Tested in the vehicle by On Board Diagnostic (OBD)
11. Securing clip
-
For wiring harness to transmission housing
12. Wiring harness
-
For solenoid valves and transmission sensors
13. O-ring
-
Always replace
-
For connector/wiring harness
14. O-ring
-
Always replace
-
Removing and installing
15. O-ring
-
Always replace
- Removing and installing
16. Valve body
-
Removing and installing
-
Designation of solenoid valves = Fig. 2
17. Cap
-
To secure level plug after checking ATF level
-
Always replace
18. Plug
19. O-ring
-
Always replace
20. Breather cap
21. Bolt, 8 Nm
22. Valve body cover
-
Removing and installing
23. Bolt, 8 Nm
-
Observe assembly sequence
24. Wiring harness
-
For transmission sensors
25. Manual valve
-
Secure against falling out when removing valve body
Fig. 1 Replacing drain plug seal
-
Cut open seal -arrow- with side cutting pliers; always replace seal.
-
Following repair work, install new seal to plug and screw in hand-tight to fill with ATF.
-
Fill transmission with ATF; check ATF level and top up if necessary.